1654304 - Error Save Failed Occurs While Creating a Material with Particular UoM

When you create a new material with UoM as Gram per liter and Kilogram per cubic meter, system throws error message 'Save Failed'.

SAP Business ByDesign

Prerequisite: An UoM like Gram per liter and Kilogram per cubic meter exists in Business Configuration Work Center.

1. Go to Product Data Work Center.
2. Select New Material under Common Tasks.
3. Assign the created UoM as Base UoM.
4. Select Save button, then the error would occur.

Non-summable quantities like gram per liter and kilogram per cubic meter cannot be used as a unit of measure (UoM). These cannot be considered as base units of measure because they represent the density of the material, which is a derived quantity containing two variable measures. Therefore, they cannot be summed up.

Removing grams per liter alone will fix this error, but use of any of the other UoMs mentioned below will cause similar issue again.

Gram per cubic centimeter
Pound per cubic foot
Gram per cubic meter
Kilogram per cubic decimeter
Kilogram per liter
Kilo mole per cubic meter
Mega gram per cubic meter
Mole per cubic decimeter
Mole per cubic meter
Mole per liter
Ton per cubic meter
Pound per gallon (US)
Gram per milliliter
Gram per liter
Milligram per cubic meter
Microgram per cubic meter
Kilogram per cubic meter
Pound per cubic inch
Milligram per liter

The solution would be to correct the Business Configuration settings accordingly.

1. Go to the Business Configuration Work Center.
2. Select Open Activity List button.
3. Select Fine Tune chevron.
4. Select the Quantities & Units of measure activity.
5. Remove the Units Gram per liter and Kilogram per cubic meter.
6. Select Save button.

Save Failed, Material, Product, Master Data, Base UoM , KBA , AP-SIP , Supplier Invoice Processing , Product Enhancement