SAP Knowledge Base Article - Preview

2264542 - "Port number must be in the range from 1 to 65535" occurs during PI initial setup wizard

Symptom

After you install a new PI dual-stack system, it is a mandatory step to run PI NetWeaver initial setup wizard as mentioned in note 1309239. On the step "Check SLD Access for PIAFUSER", the error "Port number must be in the range from 1 to 65535" occurs as below:

  13Capture.PNG


Read more...

Environment

  • SAP NetWeaver Process Integration 7.1
  • SAP enhancement package 1 for SAP NetWeaver Process Integration 7.1
  • SAP NetWeaver 7.3
  • SAP enhancement package 1 for SAP NetWeaver 7.3
  • SAP NetWeaver 7.4

Product

SAP NetWeaver 7.3 ; SAP NetWeaver 7.4 ; SAP NetWeaver Process Integration 7.1 ; SAP enhancement package 1 for SAP NetWeaver 7.3 ; SAP enhancement package 1 for SAP NetWeaver Process Integration 7.1

Keywords

CTC wizard, initial setup, functional unit, check SLD access, port number,  Process Integration 7.30, PI 7.30, Process Integration 7.31, PI 7.31, Process Orchestration 7.4, PI 7.4, PO 7.4 , KBA , BC-XI-CTC , CTC Templates for PI configuration , Problem

About this page

This is a preview of a SAP Knowledge Base Article. Click more to access the full version on SAP for Me (Login required).

Search for additional results

Visit SAP Support Portal's SAP Notes and KBA Search.