3302765 - Unable to load 0MATERIAL in SAP BW Bridge

When loading data to InfoObject 0MATERIAL in SAP BW bridge you might see one of the following errors: 

1. "Settings for material number conversion not found". (Message No: BMG135)
2. "Data record &2 ('&3'): Version '&4' is not valid". (Message No: RSDMD194)
   

*1st error can also occur when attempting to maintain 0MATERIAL via the InfoObject Maintenance. 

If you load data for InfoObject 0MATERIAL, it may be necessary to adapt the customizing settings for material numbers in transaction OMSL.

The access to SAP GUI is not possible for customers in the SAP BW bridge. More details available in SAP Help: Acquiring and Combining Data. 

SAP plans to offer OMSL customization in BW bridge cockpit in the future. Until then, the change must be requested via SAP Case under DS-BWB component, and you must provide the exact values for each one of below parameters: 

Usually, the settings are made in an ERP or S/4HANA. (More details available in SAP Note 2422224 - SAP S/4HANA Long Material number integration with SAP BW / SAP BW/4HANA)

2422224 - SAP S/4HANA Long Material number integration with SAP BW / SAP BW/4HANA 

Acquiring and Combining Data

OMSL, TMCNV, MATN1 conversion exit, 0MATERIAL, CONVERSION_EXIT_MATN1_INPUT, bridge, conversion exit, tenant, RSDMD194, material number length , KBA , DS-BWB , BW Bridge , Problem