3654446 - Test RF Environment - Personas flavor is not applied after transport

• The Test RF application is not retrieving the new personas flavor set up in the Test system after the transport.
• The issue is observed in the test system where the flavor is not displayed as expected, while it works correctly in the development system.

SAP Screen Personas

1. After transport, observe the flavor in Test RF Environment is not displayed as expected in target system.
2. Compare the behavior with the source system, where the flavor is displayed correctly.

• The Presentation Device configuration is inconsistent across the DEV, TEST, and PROD environments.
• The screen number that SAP Screen Personas relies on differs, preventing changes from being applied after the flavor is transported to another system.
• IMPORTANT: If you have different presentation devices, then create several flavors - one for each presentation device. If you create a flavor using a presentation device different than the one you use later, the flavor may not fit or work as expected. 

1. Open the "Maintain Presentation Devices" (/SCWM/PRDVC) application.
2. Compare the configuration settings between the source and target systems.
3. Ensure that all settings, including display profile, layout, and other configurations, are consistent across the DEV, TEST, and PROD environments.
4. Pay attention to the "Default" device in the same application, as this device will be activated on the RFUI Logon screen.

SAP Screen Personas for Mobile RF Devices in Extended Warehouse Management in SAP S/4HANA

Maintain Presentation Devices

SAP Note 2524406 - Using the Launchpad for EWM in S/4HANA 

test rf application, sap screen personas, flavor not displayed, maintain presentation devices, rfui, sap s/4hana cloud, transport requests, inconsistent configuration, presentation device settings, /SCWM/RFUI , KBA , BC-PER , SAP Screen Personas , SCM-EWM-RF , Radio Frequency Processing , Problem